Can you get higher than 100W equivalent? We have some low-energy bulb which IIRC claims to be equivalent to 200W which is very good as a single bulb in a large room...
- Visitors can check out the Forum FAQ by clicking this link. You have to register before you can post: click the REGISTER link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. View our Forum Privacy Policy.
- Want to receive the latest contracting news and advice straight to your inbox? Sign up to the ContractorUK newsletter here. Every sign up will also be entered into a draw to WIN £100 Amazon vouchers!
LED GU10 downlighters.. experiences?
Collapse
X
-
Originally posted by MaryPoppinsI'd still not breastfeed a naziOriginally posted by vetranUrine is quite nourishing -
83??? In one house?Originally posted by northernladuk View PostSmashing thanks for that. Just counted up and I have 83 of them to replace.
Coffee's for closersComment
-
LED GU10 downlighters.. experiences?
Good thing about the LEDs too is they're stone cold to touch when on, bloody halogens can take your skin off. That's where the leccys going - heat not light!Comment
-
I don't know but the type of light is completely different. The max cone of light you get from an LED appears to be 120 degrees which is no good as a comparison to a bulb for a single room.Originally posted by d000hg View PostCan you get higher than 100W equivalent? We have some low-energy bulb which IIRC claims to be equivalent to 200W which is very good as a single bulb in a large room...'CUK forum personality of 2011 - Winner - Yes really!!!!
Comment
-
YeahOriginally posted by Spacecadet View Post83??? In one house?
and the two kids bedrooms have a normal single bulb!
'CUK forum personality of 2011 - Winner - Yes really!!!!
Comment
-
I've got them in my kitchen, bedroom and lounge. I went for these for the lounge as they are "warm white". It's a relatively small house so we got away with replacing a 200w equivalent lamp with 6 of these and it is plenty bright enough without being harsh.
We've only had the downlighters in the lounge for 2 months and had already blown 3 halgens in there - so far the LED's are holding up well (6 months) and are pretty much a straight-swap for halogens (or the ones I bought were).Comment
-
Bought 12 off ebay and failed in weeks.
got a load from B&Q half price when they were launching their Dial range. about £5 each.
4.5 - 6w and been reliable so far. about 35w equivalent.
The kitchen ones are hardly switched off.
Agree a bit stark but its a kitchen.Comment
-
My brother has LED in his kitchen and I was unimpressed with the light level.
The wife and I looked at some LED ones for our kitchen and they were quite expensive, wasn't sure if they would pay for themselves.
May look again as the technology improves.Never has a man been heard to say on his death bed that he wishes he'd spent more time in the office.Comment
-
It's worthwhile looking at a few different models. The ones we got are brighter than the halogen bulbs they replaced.Originally posted by Scrag Meister View PostMy brother has LED in his kitchen and I was unimpressed with the light level.
The wife and I looked at some LED ones for our kitchen and they were quite expensive, wasn't sure if they would pay for themselves.
May look again as the technology improves.Coffee's for closersComment
-
I can report some success. We've got over 100 of the things - of which 14 take square halogen 12v MR16 bulbs (yes, square) in square holders. They burn out all the time and I've replaced countless transformers and tails in the past two years that we've been living here. I've got a box full of spare transformers and tails as I'm so used to swapping them out.
I tried one of these as a square bulb and holder replacement and it's been running for a couple of weeks with no issues - plus I went for the 3.5w and it's nice and bright. I've just ordered another 13 to replace all the square 12v halogens with 240v GU10s in our bedroom and en-suite. Even if the bulbs fail, for under a tenner each, as I needed to sort the square problem, it's no big deal.
If they work OK in the longer term, I'll replace all the other halogens plus the LEDs I've already fitted with these as they look really smart - much better than the simple ring fittings we have everywhere else.Last edited by Lockhouse; 8 May 2013, 09:07....my quagmire of greed....my cesspit of laziness and unfairness....all I am doing is sticking two fingers up at nurses, doctors and other hard working employed professionals...
Comment
- Home
- News & Features
- First Timers
- IR35 / S660 / BN66
- Employee Benefit Trusts
- Agency Workers Regulations
- MSC Legislation
- Limited Companies
- Dividends
- Umbrella Company
- VAT / Flat Rate VAT
- Job News & Guides
- Money News & Guides
- Guide to Contracts
- Successful Contracting
- Contracting Overseas
- Contractor Calculators
- MVL
- Contractor Expenses
Advertisers
Contractor Services
CUK News
- Is permanent employment still the safer bet? Yes, but it's a lot less safe than it used to be. Today 04:34
- Is your Director’s Loan Account (DLA) a target of HMRC’s closer look at close companies? May 29 04:45
- Is your Director’s Loan Account (DLS) a target of HMRC’s closer look at close companies? May 29 04:45
- Contractors, are you making any of the five big limited company bank account mistakes of 2026? May 28 05:51
- ‘Welcome’ increase in HMRC mileage rates for contractors using their own cars for work May 27 05:18
- King’s Speech 2026 including a welcome Late Payments Bill still leaves contractors short May 26 04:42
- Getting a mortgage when you're a contractor. The system wasn't built for you. Is that finally changing? May 22 06:11
- How deepfake AI contractors threaten umbrella company supply chains under JSL May 20 06:31
- Mileage rates review: Will the first AMAP rethink in 15 years benefit contractors? May 19 05:57
- What is a Forward Deployed Engineer (FDE), and are FDE jobs for IT contractors ripe? May 18 04:43

Comment