
I've also been busy in the kitchen, for tomorrow sees the coming of the washer-dryer installers! During a quiet spell this afternoon, I made sure the new drain hose would reach by poking it through the hole it has to go through behind the cabinets, then scrabbling in an undignified manner inside the cupboard under the sink until I was able to pull it through. It turns out it's long enough that they'll be able to attach it to the machine with it there, so there was no need to extract it again and it's good to go.
This evening, the question arose of the water inlet hose extension and the power lead, which had to go through another hole, lower down. I joined them together with one of those thick elastic bands a postman had dropped on the stairs a while back, and did some more scrabbling. The extension, being 3m, was never going to be a problem, but I wasn't sure about the power lead. Turns out it's long enough that even with the machine out where they can work on it, it can still reach its intended socket, so both of those are also ready and the installers won't have to abase themselves!

One minor point which I luckily spotted: the water hose appears to have two identical ends, one to screw onto the water thing and one to screw on to the adapter that will join it to the hose that's already on the machine. But it turns out one end has a fine gauze filter fitted which needs to be at the tap! There are no instructions but I'd seen mention of the filter in the manual, so it's a good job I checked and pulled it through the right way round or I would have risked humiliation in the eyes of the installers

So that's all as ready as I can make it, except for removing the blanking cap and refitting the drain adaptor, which will only take a minute or two in the morning… I hope

Goodnight all


Leave a comment: