
The hose connects to the sink drain, which isn’t ideal but that’s how it is. The problem was that the way the hose wanted to lie would gradually turn the thing it’s attached to until the hose itself was sagging, meaning waste water would collect in there, leading to an unpleasant smell of drains filling the kitchen when the washing machine expelled water, especially if it hadn’t been used for a few days in hot weather

The thing it’s connected to turns reasonably freely, without compromising its watertightness, and when the machine was installed last year it was left pointing up but had gradually moved round. This also meant the drooping hose was in the way. So I bought some hose brackets off Amazon (I only needed one for this but they came in a bag of loads of them) and have been meaning to get around to sorting it out.
However, the place where I needed to drill to attach the bracket is at the far back of the cupboard. It’s not too hard to reach if you’re reasonably limber, which is how I discovered that if I ever was limber, I’m not now

But with some awkward contortions I eventually managed to drill in the right place and get the back of the bracket screwed on. And once I’d carefully turned the hose upwards to get it into position across the bracket, I was able to get the front of the bracket in place and bolt it on, so now it’s sorted!

The dishwasher’s on at the moment and I don’t trust my third floor water supply to handle that and the washing machine if they both ask for water simultaneously. But once that’s done, I’ll run a fluff-clearing cycle just to make sure I haven’t inadvertently introduced any leaks




.

Leave a comment: