- Visitors can check out the Forum FAQ by clicking this link. You have to register before you can post: click the REGISTER link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. View our Forum Privacy Policy.
- Want to receive the latest contracting news and advice straight to your inbox? Sign up to the ContractorUK newsletter here. Every sign up will also be entered into a draw to WIN £100 Amazon vouchers!
Reply to: PC won't post/boot
Collapse
You are not logged in or you do not have permission to access this page. This could be due to one of several reasons:
- You are not logged in. If you are already registered, fill in the form below to log in, or follow the "Sign Up" link to register a new account.
- You may not have sufficient privileges to access this page. Are you trying to edit someone else's post, access administrative features or some other privileged system?
- If you are trying to post, the administrator may have disabled your account, or it may be awaiting activation.
Logging in...
Previously on "PC won't post/boot"
Collapse
-
As ee61r says this can be caused by one faulty board. After a lighting strike on the telephone cable my PC would not boot. Took out the network card and it was ok apart from that slot.
-
I have a PC Chips ML810 that fails to start sometimes so I have to clear the CMOS settings before it will start up again. There should be a marked jumper to short otherwise remove the CMOS battery for a few minutes and see if that helps.
Leave a comment:
-
Anything written on the PCB around the light?
I had this issue on my home server, till I read the writing above the light - turned out to be a loose piece of RAM.
Leave a comment:
-
Motherboard, PSU or CPU are likely culprits.
If there is some kind of PSU issue, or a short circuit detected at power on, it will shut down to prevent further damage.
Start by disconnecting PSU connections to all components except the motherboard (hard drive, DVD drive, graphics card, etc)
Then power on - see if it does more.
If it does, then the issue may be one of the unplugged components, or it could be one of the PSU outputs (they are various voltages, polarities, etc)
plug each component back in and power on, one component at a time until it breaks again.
If nothing more happens with everything disconnected, then remove and re-seat the CPU and try again.
Rob
Leave a comment:
-
PC won't post/boot
Ok so I've had the lid off.
When it tries to start the CPU and PSU fans spin briefly then stop. No beep, nada. There is an orange light that remains lit on the mboard.
Any ideas?
TIATags: None
- Home
- News & Features
- First Timers
- IR35 / S660 / BN66
- Employee Benefit Trusts
- Agency Workers Regulations
- MSC Legislation
- Limited Companies
- Dividends
- Umbrella Company
- VAT / Flat Rate VAT
- Job News & Guides
- Money News & Guides
- Guide to Contracts
- Successful Contracting
- Contracting Overseas
- Contractor Calculators
- MVL
- Contractor Expenses
Advertisers
Contractor Services
CUK News
- Loan Recall Case Study: Amanda Today 06:00
- How IR35 inflated an £8.5bn consultancy bill — and tests Burnham at the Budget Aug 28 07:47
- Autumn Budget 2026: FCSA’s 5 contractor asks of John Healey Aug 27 04:15
- Andy Burnham's Zoom gripe doesn’t apply to IT contractors, say recruiters Aug 26 03:41
- Check your Loan Recall paperwork for the Isle of Man: it could matter Aug 25 03:27
- Budget 2026: Contractor advisers ask for ‘IR35 reset’ Aug 24 04:57
- Why might an umbrella company fail to pay its total tax bill to HMRC? Aug 18 06:08
- Contractors, here are the late payment fixes that the Lords just turned down Aug 17 08:03
- How will HMRC's Direct Debit plan affect contractors paying VAT and PAYE? Aug 13 23:54
- HMRC's new 'reckless' tax offence: an IR35 game-changer for contractors? Aug 13 13:50

Leave a comment: