ommm...
- Visitors can check out the Forum FAQ by clicking this link. You have to register before you can post: click the REGISTER link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. View our Forum Privacy Policy.
- Want to receive the latest contracting news and advice straight to your inbox? Sign up to the ContractorUK newsletter here. Every sign up will also be entered into a draw to WIN £100 Amazon vouchers!
test please delete
Collapse
This is a sticky topic.
X
X
Collapse
-
-
Comment
-
Been past the petrol station in this article loads of times: BBC News - England's most unusual listed buildings
Never realised it was a listed buildingComment
-
Shockingly bad service at La Tasca tonight. Waited over an hour and a half for pre-ordered food (a set menu - everyone had the same), then half the dishes never turned up. The dessert (cheesecake) was still frozen when served. But being a friend's 40th, didn't want to make too much fuss and spoil her night.Comment
-
Absolutely chucking it down here now. Well, not actually here - out there *gestures towards window*Comment
-
-
-
Originally posted by test please delete View PostGreetings.
This is a short message to thank you all for continuing to post in me. Your valuable contributions are all very much appreciated.
Kind Regards
tpd
Comment
-
Originally posted by barrydidit View PostYep.
<mrs beaton mode>
First feed the cotton from your bobbin to the needle
</mrs beeton mode>
Then, position fabric suitably, and move it between the foot and the plate whilst depressing pedal accordingly.
Snap the thread from below the needle point once all sewing is complete/one wishes to start sewing from a different place on the same fabric.
As far as I have observed (and I have observed extensively), the 'winding thread onto bobbin and then threading the machine' part of the operation is where 80% of the skill is involved. The other 20% being in not sewing ones digits to a piece of fabric.
Is this a manual specimin, or an early electric model?
The electric bit looks like it was designed by Edison.Comment
-
- Home
- News & Features
- First Timers
- IR35 / S660 / BN66
- Employee Benefit Trusts
- Agency Workers Regulations
- MSC Legislation
- Limited Companies
- Dividends
- Umbrella Company
- VAT / Flat Rate VAT
- Job News & Guides
- Money News & Guides
- Guide to Contracts
- Successful Contracting
- Contracting Overseas
- Contractor Calculators
- MVL
- Contractor Expenses
Advertisers
Contractor Services
CUK News
- Autumn Budget 2024: Umbrella companies hit, Employer NICs hiked, and BADR heading for 18% Today 16:54
- Autumn Budget 2024: chancellor’s full speech Today 16:34
- RecExpo got told this about Labour’s Employment Rights Bill… Today 09:10
- A limited company just got one over HMRC on VAT; here’s how Yesterday 09:24
- Top 5 Autumn Budget areas for IT contractors to tick off Oct 28 09:30
- Top 5 umbrella company expenses things to still do in 2024 under 2016's T&S rules Oct 24 08:21
- PGMOL ties up Mutuality but Control’s new low bar is a concern set to run and run Oct 23 08:10
- What the PGMOL case really means for IT contractors Oct 22 08:30
- HMRC blacklists 16 tax avoidance schemes in just four weeks Oct 21 08:15
- Form CS01: What it is, and how to file with Companies House Oct 17 08:22
Comment