Visitors can check out the Forum FAQ by clicking this link. You have to register before you can post: click the REGISTER link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. View our Forum Privacy Policy.
Want to receive the latest contracting news and advice straight to your inbox? Sign up to the ContractorUK newsletter here. Every sign up will also be entered into a draw to WIN £100 Amazon vouchers!
You are not logged in or you do not have permission to access this page. This could be due to one of several reasons:
You are not logged in. If you are already registered, fill in the form below to log in, or follow the "Sign Up" link to register a new account.
You may not have sufficient privileges to access this page. Are you trying to edit someone else's post, access administrative features or some other privileged system?
If you are trying to post, the administrator may have disabled your account, or it may be awaiting activation.
Just looks like a fecking big magnet & a plate to me.
It would be a piece of piss to design an electromechanical bell ringer though. All you need is an offset weight which a motor turns via a ratchet on a central axis. When it reaches the top of its turn it drops down and moves the clapper via an elliptical shaped cam to strike the inside of the bell, and then the weight starts climbing again ready for the next strike, and so on.
Looks like a the large cyclinder on the lower left is steadily rotated clockwise (away from the vertical) by a motor, until at some point it suddenly falls back and causes the hammer to strike the bell.
Leave a comment: