Back to the original question …
For 200 users I would def go 1Gb between servers, with 1Gb drop down to 100Mb switches that distribute out to the users etc.
I am not sure what the server requirements are for 200 users? But assuming that they are “normal” IE a couple of file / print servers, email server, SQL server etc then 100mb to the users will be fine.
*If* the network then appears slow then go back to basics – actually time how long a 1Gb file transfer takes between servers and then from the server to the user – try to find the bottle neck.
Sometimes you are better to strap the inter server / switch links to 1000mbs full duplex than allowing them to remain on auto. – file transfer test will prove.
Slow networks are often (blamed) but found not to be the bottleneck – IMO slow server disk subsystems are the culprit – again a file transfer test will help to diagnose.
Look for horrid disk fragmentation (Windows servers) as well as physical disk read / writes – there are some really slow SCSI U320 disk out there believe me.
Is the server running a disk array, if so is the RAID controller set up for write through or write back?
Run a performance bench mark
http://www.passmark.com/ on the server disk read writes - are they as expected.NB C: drives on windows servers are deliberately slowed down for disk writes (protection against power fail), D Drive is not so expect better read / write.
If the servers can serve up! as expected then look again at the basics.
I just “fixed” a slow 300 user network by replacing the cables used to patch the servers running at 1Gb with certified CAT6 patch leads – but here there were lots of errors reported on the switches with often server network dropouts. I was the second contractor in after the first one failed to spot the dodgy leads.